Changing Bulbs - Seat Arona Owner's Manual

No. Consumer/Amps
Petrol engine pump relay (MPI), Gauge
4
control unit (TSI and diesel)
Pressure transducer, EPW Solenoid
Valve, TOG Sensor, PWM Electric fan,
5 Camshaft Control Valve, Active Carbon
Tank Valve and Oil Pressure Regulat-
ing Valve (TSI)
Ignition coils (MPI and TSI)
6
Glow plug relay, Suction hose resist-
ance (diesel)
7 Vacuum pump (TSI)
Injectors and EKP Relay Coil (MPI and
8
CNG), Fuel metering valve (diesel)
9 Servo sensor
10 Vref Battery: Gateway, BDM and BCM
Engine Injection Module, Main Engine
14
Relay, ESC
15 Automatic Gearbox DQ200 and AQ160
17 50 Diag
18 Starter Motor
ESC (Pump)
20
ABS (Pump)
21 ESC/ABS (Valves)
TH4 Electric fan without A/C for mod-
24
erate climate countries
106
Emergencies
No. Consumer/Amps
TH4 fan with A/C or T5I for moderate
15
climate countries
25
PTC1
TJ1/TJ4/TJ7/T6P or TH4/T5I Electric fan
10
26
for warm climate countries
TH4 fan with A/C or T5I for moderate
climate countries
20
27
PTC2
7.5
28 PTC3
15
10

Changing bulbs

7.5
General notes
7.5
Read the additional information carefully
7.5
›››

page 63
Changing bulbs requires a certain degree of
30
practical skill.
7.5
If you choose to change the engine compart-
30
ment lamps yourself, remember that it is a
›››
dangerous area in Safety notes for work
60
in the engine compartment on page
40
Always use identical bulbs with the same
25
designation. The name can be found on the
base of the bulb holder.
30
Depending on how equipped the vehicle is,
there are different sets of headlights and tail
lights:
20
Halogen headlights.
●
40
● Full-LED main headlights*
Halogen headlights with LED daytime run-
●
50
ning lights*
Rear bulb light
●
30
● LED rear light*
40
Full-LED headlight system*
40
Full-LED headlights handle all light functions
(daylight, side light, turn signal, dipped
beam and route light) with light emitting di-
odes (LEDs) as a light source.
Full-LED headlights are designed to last the
lifetime of the vehicle and the bulbs cannot
be replaced. In case of headlight failure, go
to an authorised workshop to have it re-
placed.
WARNING
Take particular care when working on com-
●
ponents in the engine compartment if the en-
gine is warm, there is a risk of burns.
273.
Bulbs are highly sensitive to pressure. The
●
glass can break when you touch the bulb,
causing injury.
When changing bulbs, please take care not
●
to injure yourself on sharp parts in the head-
light housing.