Accessing The Hard Disk Drive Carrier - Xplore iX104C5 User Handbook Manual

Chapter 2. Using the Tablet
Accessing the drive carrier
Removing the drive carrier
66
When you install a new storage drive, follow the instructions in this
section to access the hard disk drive carrier.
WARNING Failure to follow this procedure can result in
damage to the case and the cover, which is not
covered under the Xplore Technologies warranty.
Xplore recommends that you use an
approved Xplore Technologies service center
for this procedure.
1.
Turn off the computer.
2.
Remove all power from the unit, including batteries and other
power sources such as power supplies, cigarette lighter adapters,
and mobile power sources.
Pinch the two center pins with one hand while pushing down on
3.
the lever with the other. The drive carrier will pop up (like the battery)
and permit removal. NOTE: Your drive carrier may have two screws installed.
If so, remove them prior to exchanging the drive carrier
iX104C5 User's Handbook