Replacing Side Panels Onto Unit; Mounting Duct Sections And Grilles (Accessories); Switching On And Checking Operation - Biddle DECO 50 Manual

I
NSTALLATION
2.12

Replacing side panels onto unit

2.13

Mounting duct sections and grilles (accessories)

2.14

Switching on and checking operation

24
1
Cased models only
1. Hook the side panels into the three eyes on the unit's side
face.
2. Fix the panel to the front face using screw 1.
3. Position the filter frame, and fix it with the quarter-turn
fasteners.
Chassis models only
The unit may be provided with flexible connection sleeves or
with flanges to which duct sections or grilles can be con-
nected. Mounting these parts depends on the local situation,
and is to be carried out according to your own judgment. Fol-
low the below instructions in order not to affect the unit's
performance:
• Avoid abrupt duct transitions.
• Keep ducts as short as possible.
• Do not apply any grille that is much smaller than the unit
opening.
• Mount flexible connection sleeves to the inlet opening
under tension; this is to prevent the connection sleeve
from being closed at high fan speeds.
All models
1. Check the power supply connection.
2. Check the controller connections (see the corresponding
documentation).
3. Switch on the mains supply.
4. Make the controller ready for use according to the appro-
priate manual.
F C U
AN OIL NIT