Mounting; Removing Side Panels From Unit; Mounting Unit; Determining Mounting Position And Method - Biddle DECO 50 Manual

I
NSTALLATION
2.7

Removing side panels from unit

2.8

Mounting unit

16
1

2.6.2 Mounting

1. Apply expanding foam gasket (included) around the inlet
section's ventilation opening.
2. Make an opening through the wall (see Table 2-3 for
dimensions).
3. Fix four M8 bolts into the wall. (The dimensions are identi-
cal to those for fixing the unit: see Table 2-4 on page 18.)
Make sure the bolts are level.
4. Suspend the inlet section from the bolts using the key-
holes in the back.
5. Tighten the bolts.
Cased models only
To make the unit accessible for mounting it and for con-
necting water pipes and/or electric wiring, the side panels
must be removed.
1. Loosen the quarter-turn fasteners, and remove the filter
frame.
2. Behind the frame, each face has a screw 1 that holds the
side panel in place. Remove this screw.
3. Lift the panel carefully, and remove it forward.

2.8.1 Determining mounting position and method

All models
• Make sure the structure from which the fan coil unit is to
be suspended is capable of bearing the unit. The weight is
specified on the type plate (see section 1.3.4).
• Ensure the air can flow freely through the unit's inlet and
discharge openings.
• Position the unit such that the connections will be easy to
access both during and after installation.
F C U
AN OIL NIT