Mounting Wall Model; Mounting Wall Model To Attenuated Inlet Section - Biddle DECO 50 Manual

M
ANUAL
Version: 4.0 (19-12-2007)

2.8.3 Mounting wall model

Floor positioning
1. Position the unit on the surface, and stabilise and level it
using the adjusting feet in the bottom.
2. You may want to secure the unit to the wall. (See below.)
Suspending from or securing to wall
1. Apply four M8 bolts. (For dimensions, see Table 2-4.)
Ensure the bolts are level.
2. Suspend the unit from the bolts. Perform this with at least
two persons. (The unit's weight is specified on the type
plate, see section 1.3.4.)
3. Tighten the bolts.
4. Check the suspension for stability:
- Try to push the unit from the bolts.
- Shake the unit for a few seconds.

2.8.4 Mounting wall model to attenuated inlet section

Floor positioning
1. Position the unit against the inlet section at equal heights
on the floor. The edge of the inlet section should enclose
the back panel of the unit.
2. Stabilise and level the unit using the adjusting feet in the
bottom.
3. Secure the unit to the inlet section using 4 M8 bolts,
through the keyholes in the back panel.
Suspending from inlet section
1. Ensure the unit has the same height as the inlet section by
using a temporary prop.
n
Note:
It is not possible to hook the unit onto the inlet section
using the keyholes.
2. Place the unit against the inlet section: the edge of the inlet
section should enclose the back panel of the unit.
I
NSTALLATION
19