Alfa Romeo 4C Owner's Handbook Manual page 98

CHECKING AND RESTORING TYRE
PRESSURE
The compressor can also be used to
check and, if necessary, restore the tyre
pressure.
Release quick connector 1 fig. 83 and
connect it directly to the valve of the tyre
to be inflated.
83
96
REPLACING THE BOTTLE
Proceed as follows:
❒ release connector 1 fig. 84 and
disconnect tube 2;
❒ turn the bottle anticlockwise to
replace and raise it;
❒ fit the new cylinder and turn it
clockwise;
❒ insert connector 1 and tube 2 in
position.
A0L0081
84
IMPORTANT
102) Indicate the presence of the
stationary car in accordance with current
regulations: hazard warning lights,
warning triangle, etc. Those on board
should get out of the vehicle and wait for
the wheel to be repaired away from the
threat posed by the traffic. If parked on a
slope or rough surface, chock the wheels
with wedges or other suitable devices
(for the correct procedure for parking the
car safely, refer to the "Parking"
paragraph in the "Starting and driving"
chapter).
103) A repair is not possible if the wheel
rim is damaged (groove is deformed,
causing air to escape). Do not remove
foreign bodies (screws or nails) from the
tyre.
104) Give the booklet to the technicians
who will be handling the tyre that was
treated using the "Fix&Go Automatic" kit.
105) Do not operate the compressor for
longer than 20 consecutive minutes.
A0L0082
Risk of overheating. The kit is not suitable
for definitive repairs, so the repaired
tyres may only be used temporarily.