Alfa Romeo 4C Owner's Handbook Manual page 97

INFLATION PROCEDURE
Proceed as follows:
107)
❒ engage the handbrake, unscrew the
tyre valve cap, take out filler hose
1 fig. 80 and tighten ring nut 2 on the tyre
valve;
80
❒ make sure that switch 1 fig. 81 for the
compressor is in position 0 (off), start the
engine, insert the plug into the cigar
lighter socket on the central tunnel
(see fig. 82) and switch on the
compressor by bringing switch 1 fig. 81
to I (on);
1
81
A0L0078
82
❒ inflate the tyre to the pressure
indicated in the "Wheels" paragraph in the
"Technical data" chapter. In order to
obtain a precise reading, check the
pressure on pressure gauge 1 fig. 81 with
the compressor off;
❒ if after 5 minutes it is impossible to
reach at least 1.8 bar,
❒ disconnect the compressor from the
valve and power socket, then move the
car forwards approximately 10 metres in
A
order to distribute the sealant inside the
tyre evenly, then repeat the inflation
operation;
❒ if you still cannot obtain a pressure of
at least 1.8 bar within 5 minutes from the
compressor switching on, do not drive off
and contact a dedicated Alfa Romeo
A0L0079
Dealership;
❒ after driving for about 10 minutes
stop and check the tyre pressure again;
remember to engage the handbrake;
❒ if a pressure value of at least 1.8 bar
is detected, restore the correct pressure
(with the engine running and the
handbrake engaged), resume driving and
drive with great care to a dedicated Alfa
Romeo Dealership.
108) 109) 110)
A0L0080
95