Alfa Romeo 4C Owner's Handbook Manual page 94

IMPORTANT Make sure that the upper
part 2 of the jack rests firmly on the
undercarriage of the car in the points
shown in fig. 75, 76 to prevent the car
from falling while it is being jacked up.
76
100)
❒ operate the jack and lift the car until
the wheel is several
centimetres off the ground;
❒ alert any bystander that the car is
about to be raised; all persons should be
kept away from the car and nobody must
touch it until it has been lowered;
❒ remove the damaged wheel;
92
❒ make sure the contact surfaces
between space-saver wheel and hub are
clean and free from impurities so that the
fixing stud bolts will not come loose;
❒ fit the space-saver wheel and tighten
the first stud bolt for a few turns into the
lowest hole. Tighten the remaining stud
bolts in the same way.
❒ take the spanner 1 fig. 70 and fully
tighten the fixing stud bolts;
❒ operate the suitable tool 4 fig. 72 to
lower the car.
Then extract the jack;
❒ using spanner 1 fig. 70 tighten the
stud bolts fully, alternating from a stud
A0L0188
bolt to the diametrically opposite one,
❒ in the numeric order shown in fig. 77.
WARNING While replacing the wheel it is
advisable to place it upside down, with
the aesthetic part facing upward, so as
not to damage the alloy rim.
REFITTING THE WHEEL
Following the procedure described
previously, raise the vehicle and remove
the space-saver wheel.
Proceed as follows:
❒ make sure the contact surfaces
between standard wheel and hub are
clean and free from impurities so that the
fixing stud bolts will not come loose;
❒ using the spanner 1 fig. 70 and tighten
the fixing stud bolts;
❒ lower the vehicle and remove the jack;
❒ use spanner 1 to fully tighten the stud
bolts, following the order shown in 77.
101)
77
A0L0187