Accelerated Care Plus OMNISOUND 3000C PRO User Manual page 12

®
OMNISOUND 3000C PRO USER MANUAL

M.) Transducer Data

E.) Frequency

D.) Duty Factor
H. The CONTRAST button is used to lighten or darken the digital screen contrast.
I. The transducer SELECT button will alternate selected transducer from MAIN or AUX.
J. Transducer cable plug-in socket used to connect the transducer to the unit. The socket marked as MAIN must
be used when only one transducer is used with the unit.
K. Transducer cable connector inserts into the plug-in socket for connection of the transducer to the unit.
L. Transducer coaxial cable.
M. Pressing this button displays the transducer BNR and ERA. Pushing ASSIST button followed by this button
will display the date of last calibration.
N. The OUPUT button is used to enable power calibration of the generator and the selected transducer.
O. This button is used to set the TEMP mode, and activate the Delta T mode.
P. The POWER/INTENSITY button is used to toggle the display in watts (power) or watts/cm² (intensity).
Q. The cooling fan provides airflow through the unit when the unit is operational.
R. The ELECTROSTIM INPUT PORT is used to connect the shrouded pin-to-banana adaptor (Item No. 2503036)
and lead wire from electro-stimulator for combination therapy.
S. Toggle POWER switch; turn on AC power when set to 1, and turns off the AC power when set to 0.
T. The carry handle for easy transport of the equipment.
U. AC line cord receptacle, where the power cord is plugged in.
V. The generator CAUTION LABEL is located on bottom of the unit.
W. Two TRANSDUCER HEADS come standard with the unit (both 2 and 5 cm²), and both are adjustable to any
angle from 0 to 360º.
X. The TRANSDUCER LABEL lists the transducer serial number, BNR and ERA data.
Y. The FREQUENCY button is used to select:

1 MHz for deep tissue penetration, or

3 MHz for superficial tissue penetration.
Z. The DELTA T temperature mode select button is used to activate temperature calculation mode.
AA. The POWER intensity set button is used to increase and decrease the ultrasound output level.
BB. This LED is on continuously to show which transducer is selected. The LED flashes on and off when
overheated.
COPYRIGHT © 2001 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVED
9