Magma A10-701 Owner's Manual
  1. Manuals
  2. Brands
  3. Magma Manuals
  4. Grill
  5. A10-701
  6. Owner's manual

Magma A10-701 Owner's Manual

Adventurer marine series
Hide thumbs Also See for A10-701:
Table of Contents

Advertisement

Quick Links

Download this manual
Adventurer Marine Series
IMPORTANT, read these instructions carefully before use. Familiarize yourself with the
appliance before connecting it to its gas container. Keep these instructions for future reference.
OWNER'S MANUAL
GAS GRILL MODELS: A10-701, A10-703
For questions regarding performance, assembly,
operation, parts, or returns, contact the experts
at MAGMA by calling (562) 627-0500
For questions regarding performance,
assembly, operation, parts, or returns,
contact the experts at MAGMA directly
by calling TOLL FREE
7:00 a.m. - 5:00 p.m. Pacific Time Monday thru
1 - 800 - 86 - MAGMA
Friday or e-mail us at mail@MagmaProducts.com
7:00 a.m. - 5:00 p.m.
Pacific Time Monday thru Friday
or e-mail us at
magmamail@aol.com
™

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A10-701 and is the answer not in the manual?

Questions and answers

Related Manuals for Magma A10-701

Summary of Contents for Magma A10-701

  • Page 1 MAGMA directly by calling TOLL FREE 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru 1 - 800 - 86 - MAGMA Friday or e-mail us at mail@MagmaProducts.com 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at magmamail@aol.com...

  • Page 2: Important Safety Warnings

    • USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS. • FOR NATURAL GAS APPLICATION CONTACT MAGMA. • ALWAYS LIGHT GRILL WITH LID OPEN.
  • Page 3 Carriage bolt, washer & lock nut Single mount through-bolt applications 4 Carriage bolts, washers & lock nuts. Note: Place washers on carriage bolts as shown above. See Magma website for replacement part numbers and valve applications. www.MagmaProducts.com “Stay Cool” Oversized, Handlei...

  • Page 4: Operating Procedures

    OPERATE ONLY ON “LOW” WHEN LID IS CLOSED. ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat grill. Magma Grills do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed. If medium or high heat is required, grill with lid open.

  • Page 5: Disassembly And Reassembly

    DISASSEMBLY & RE-ASSEMBLY 1. Release locking 3. Release locking pin pin & lift up 2. Slide out RADIANT PLATE TURBO BURNER 1. To remove radiant plate pull locking 3. To remove burner pull locking pin. pin to release and lift plate up from left side 2.

  • Page 6: Maintenance

    Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice.

  • Page 7: Troubleshooting Guide

    USING GRILL WITH ON-BOARD CNG (NATURAL GAS) SYSTEMS • Magma on-board CNG (natural gas) valves allow Magma grills to be installed to an existing on-board, pre-regulated low pressure CNG (natural gas) system.

  • Page 8: Limited Warranty

    If the product fails to operate due to a defect in materials or workmanship during the warranty period, the defective part will be repaired or replaced at Magma's option. If you wish to obtain performance under this limited warranty, you should contact Magma's Customer Service Department via telephone at (562) 627-0500, or via e-mail at mail@MagmaProducts.com, or via U.S.

This manual is also suitable for:

A10-703

Table of Contents