Magma ChefsMate CONNOISSEUR Series Owner's Manual

Magma ChefsMate CONNOISSEUR Series Owner's Manual

Advertisement

Quick Links

CONNOISSEUR SERIES GAS GRILL
IMPORTANT, read these instructions carefully before use. Familiarize yourself with the appliance
before connecting it to its gas container. Keep these instructions for future reference.
OWNER'S MANUAL
ChefsMate
A10-803
For questions regarding performance, assembly,
operation, parts, or returns, contact the experts
at MAGMA by calling (562) 627-0500
For questions regarding performance,
assembly, operation, parts, or returns,
contact the experts at MAGMA directly
by calling TOLL FREE
7:00 a.m. - 5:00 p.m. Pacific Time Monday thru
1 - 800 - 86 - MAGMA
Friday or e-mail us at mail@MagmaProducts.com
7:00 a.m. - 5:00 p.m.
Pacific Time Monday thru Friday
or e-mail us at
magmamail@aol.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ChefsMate CONNOISSEUR Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Magma ChefsMate CONNOISSEUR Series

  • Page 1 MAGMA directly by calling TOLL FREE 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru 1 - 800 - 86 - MAGMA Friday or e-mail us at mail@MagmaProducts.com 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at magmamail@aol.com...
  • Page 2: Important Safety Warnings

    • USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS. • FOR NATURAL GAS APPLICATION CONTACT MAGMA. • ALWAYS LIGHT GRILL WITH LID OPEN.
  • Page 3 MOUNT HARDWARE Fasteners are supplied for both Single Mount and Dual Mount grill mounting options. See Magma Catalog or Website for best mount selection. Single mount through-bolt applications Dual mount applications 4 Carriage bolts, washers & lock nuts. 4 Carriage bolts, washers & lock nuts. Only 4 bolts required for grill mounting.
  • Page 4: Operating Procedures

    OPERATE ONLY ON “LOW” WHEN LID IS CLOSED. ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat grill. Magma Grills do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed. If medium or high heat is required, grill with lid open.
  • Page 5 DISASSEMBLY & RE-ASSEMBLY A - Lift radiant plate up & out of left slot. B - Remove by sliding it out of right slot. C - Remove burner screw and remove burner. Check burner for grease residue or spider webs that may obstruct gas flow. CAUTION: WHEN REPLACING BURNER, CUT SLOTS IN BURNER MUST FACE DOWN.
  • Page 6: Maintenance

    Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice.
  • Page 7: Troubleshooting Guide

    USING GRILL WITH ON-BOARD CNG (NATURAL GAS) SYSTEMS •For on-board CNG (Natural Gas) Systems, use Magma Type 4-Low Output-Low Pressure Natural Gas Control Valve. Check your local dealer for proper hose and fittings. TROUBLE SHOOTING GUIDE Possible Cause Possible Solution...
  • Page 8: Limited Warranty

    In the state of California only, if refinishing or replacement of the product is not commercially practicable, the retailer selling the product, or Magma Products, Inc., will refund the purchase price paid for the product, less the amount directly attributable to use by the original consumer prior to the discovery of the nonconformity.

This manual is also suitable for:

Chefsmate a10-803

Table of Contents