Table of Contents
Advertisement
Quick Links
ADVENTURER MARINE SERIES
A10-701
For questions regarding performance, assembly,
operation, parts, or returns, contact the experts
at MAGMA by calling (562) 627-0500
For questions regarding performance,
assembly, operation, parts, or returns,
contact the experts at MAGMA directly
7:00 a.m. - 5:00 p.m. Pacific Time Monday thru
1 - 800 - 86 - MAGMA
Friday or e-mail us at mail@MagmaProducts.com
IMPORTANT, read these instructions carefully before use. Familiarize yourself with the appliance
before connecting it to its gas container. Keep these instructions for future reference.
OWNER'S MANUAL
A10-703
A10-701-CSA
•
•
by calling TOLL FREE
7:00 a.m. - 5:00 p.m.
Pacific Time Monday thru Friday
or e-mail us at
magmamail@aol.com
A10-703-CSA
•
™
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Magma ADVENTURER MARINE Series
Summary of Contents for Magma ADVENTURER MARINE Series
- Page 1 MAGMA directly 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru by calling TOLL FREE 1 - 800 - 86 - MAGMA Friday or e-mail us at mail@MagmaProducts.com 7:00 a.m. - 5:00 p.m. Pacific Time Monday thru Friday or e-mail us at magmamail@aol.com...
-
Page 2: Important Safety Warnings
• USE PROPANE GAS ONLY. FUEL STORAGE SHOULD BE IN COMPLIANCE WITH THE AMERICAN BOAT AND YACHT COUNCIL (ABYC) STANDARDS A-1 (9), MARINE LIQUIFIED PETROLEUM GAS (LPG) SYSTEMS. • FOR NATURAL GAS APPLICATION CONTACT MAGMA. • ALWAYS LIGHT GRILL WITH LID OPEN. -
Page 3: Installation Instructions
The valve was designed to be loose fitting in order to allow safe, easy installation and removal of the propane canister and so it easily swings without resistance to fit all applications. MOUNT HARDWARE See Magma website for replacement part numbers and valve applications. Fasteners are supplied for Single Mount MagmaProducts.com... -
Page 4: Operating Procedures
OPERATE ONLY ON “LOW” WHEN LID IS CLOSED. ALWAYS OPERATE WITH GREASE TRAY IN PLACE. WARNING: Do not overheat grill. Magma Grills do not require pre-heating. Stainless Steel loses anti-corrosive characteristics when subjected to extreme heat. Most grilling is done on low temperature with the lid closed. If medium or high heat is required, grill with lid open. -
Page 5: Disassembly And Reassembly
DISASSEMBLY & RE-ASSEMBLY 1. Release locking 3. Release locking pin pin & lift up 2. Slide out RADIANT PLATE TURBO BURNER 1. To remove radiant plate pull locking 3. To remove burner pull locking pin. pin to release and lift plate up from left side 2. -
Page 6: Maintenance
Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the orifice. -
Page 7: Troubleshooting Guide
• Magma on-board CNG (natural gas) valves allow Magma grills to be installed to an existing on-board, pre-regulated low pressure CNG (natural gas) system. • Use only Magma Type 4 Low Pressure CNG (natural gas) control valves. Visit our website at MagmaProducts.com to view valve application guide. See your local dealer for proper hose and fittings. -
Page 8: Limited Warranty
Discoloration or Corrosion caused by exposure to excessive heat or failure to properly clean and care for the stainless steel surfaces. If the product fails to operate due to a defect in materials or workmanship during the warranty period, the defective part will be repaired or replaced at Magma's option. If you wish to obtain performance under this limited warranty, you should contact Magma's Customer Service Department via telephone at (562) 627-0500, or via e-mail at mail@MagmaProducts.com, or via U.S.
Need help?
Do you have a question about the ADVENTURER MARINE Series and is the answer not in the manual?
Questions and answers