Aruba 501 Configuration And Administration Manual page 66

Iperf client
When operating as an Iperf client, the Aruba 501 establishes a connection to an Ipserf server.
Remote Iperf server address
Specify the IPv4 or IPv6 address of the Iperf server. Default: 0.0.0.0.
Test duration
Specify the test duration in seconds. Range: 1 to 1800 seconds. Default: 15 seconds.
Parallel client thread
Specify the number of parallel client streams to be run. Range:1 or 2. Default: 1.
TCP/SCTP maximum segment size
Specify the maximum segment size in bytes. Range: 88 to 9216 bytes. Default: 88 bytes.
Client port
Specify the port on which the client will establish the connection. The server and the client must use the same
port settings. Range: 1 to 65535. Default: 5201.
Stream type
Select the stream type: TCP or UDP. Default: TCP.
Start/Stop
Click to start and stop the test.
Iperf server
When operating as an Iperf client, the Aruba 501 establishes a connection to an Ipserf server.
• The Iperf server supports a maximum test duration of 1800 seconds at which point the test is automatically
terminated.
Server port
Specify the port on which the server will listen for client connections. The server and the client must use the
same port settings. Range: 1 to 65535. Default: 5201.
Result
Status
Test status.
Result
Test results.
66 Aruba 501 802.11ac Wireless Client Bridge Configuration and Administration Guide