Advertisement
Preface
lists the documents detailing the setup and installation process for the IntroSpect Analyzer appliances. Refer to
these documents in the order listed.
Table 1: Related Documents
Step
Category
1
Quick Start Guide
2
Appliance Setup Guide
3
Configuration Guide
*This document.
** Future document release.
Figure 1 Aruba IntroSpect Analyzer 2XXX Series – Front View
This Quick Start Guide applies to the following models:
Table 2: IntroSpect Analyzer 2XXX Series Models
Model
AI-ANA-2000
AI-ANA-2500
Revision 3 | June 2018
Aruba IntroSpect Analyzer 2XXX Series
Document
Aruba IntroSpect Analyzer 2XXX Series Quick Start Guide*
Aruba IntroSpect Analyzer Appliance Setup Guide
Aruba IntroSpect Log Sources Configuration Guide**
Aruba IntroSpect Analytics Configuration Guide**
Name
Aruba IntroSpect Analyzer 2000 Appliance (All HDD)
Aruba IntroSpect Analyzer 2500 Appliance (with SSD)
Quick Start Guide
JSKU #
JZ263A
JZ264A
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Aruba IntroSpect Analyzer 2 Series
Summary of Contents for Aruba IntroSpect Analyzer 2 Series
- Page 1 Aruba IntroSpect Log Sources Configuration Guide** Aruba IntroSpect Analytics Configuration Guide** *This document. ** Future document release. Figure 1 Aruba IntroSpect Analyzer 2XXX Series – Front View This Quick Start Guide applies to the following models: Table 2: IntroSpect Analyzer 2XXX Series Models Model...
- Page 2 Racking the Analyzer Appliance Use the following steps to install Analyzer: Extend and Release the Inner Rails Attach Inner Rails Attach Outer Rails and Install Chassis Extend and Release the Inner Rails 1. Press the locking tabs and pull to extend the rails. 2.
- Page 3 Attach Outer Rails and Install Chassis 1. Hang the outer rail front hooks onto the front rack slots. 2. Hang the outer rail rear hooks onto the rear rack slots. 3. Align Analyzer's inner rails with the outer rails and slide unit until the locks click. Figure 4 Attach Outer Rails and Install Chassis IntroSpect Analyzer 2XXX Series | Quick Start Guide...
- Page 4 Configuring Analyzer Nodes Connect ETH1 port to a computer only for configuration purposes. It is running a DHCP server and should not be connected to any other networks. 1. IPMI LAN Port 2. Power Supply (2) 3. ETH1: Config Port 4.
- Page 5 Hewlett Packard Enterprise Company Attn: General Counsel 3000 Hanover Street Palo Alto, CA 94304 Contacting Support Table 3: Contact Information Main Site www.arubanetworks.com Support hpe-aruba-introspect-support@hpe.com Airheads Social Forums and Knowledge community.arubanetworks.com Base North American Telephone 1-800-943-4526 (Toll Free) 1-408-754-1200 International Telephone arubanetworks.com/support-services/contact-support/ Software Licensing Site hpe.com/networking/support...
Need help?
Do you have a question about the IntroSpect Analyzer 2 Series and is the answer not in the manual?
Questions and answers