Message
TSB: Connection established with TCP
xx at IP xx port xx.
TSB: Disconnection from TCP TCP xx
xx port xx.
TSB: Idle timeout on TCP xx, xx
disconnected.
TSB: Closing incoming connection
from TCP client at IP xx port xx. A
connection has already been
established.
TSB: tcpserialbridge connect to xx:xx
failed erno= xx(xx), will keep trying.
TSB: Aborting connection from TCP
client xx port xx (cause: new
connection request from same IP
address).
TSB: Server on port xx
Association to SSID x and BSSID x
unsuccessful
Deauthenticated from BSSID x with
reason xx.
Roamed to BSSID x for reason x:x.
Lost connection with BSSID x.
Association failed with status
x:Reason.
Last firmware upgrade did not
complete so still running the previous
image.
The primary image failed to load so the
secondary image was loaded.
Connected to <ssid> on channel
<channel>.
Chapter 6 Tools
Description
TCP serial connection established.
TCP serial connection terminated.
TCP serial connection disconnected due to idle
timeout.
Ignoring incoming TCP serial connection, since
a connection has already been established.
Remote TCP serial connection failed and will
retry.
Aborting previous TCP serial connection with
the same IP address since the connection was
closed.
TCP serial server is listening on port xx.
Work group bridge connection established.
Work group bridge connection terminated due
to receiving a disassociation frame.
Work group bridge roamed to a new BSSID.
Work group bridge abruptly lost contact with the
BSSID.
Association failed with status code and reason
given. Likely reasons are:
•
Failed due to no matching network found.
•
Protocol failure: packet not acknowledged.
•
Operation failed.
The attempted firmware upgrade did not
complete, and the system reverted to the
previous image.
The primary image could not be loaded, and
the system loaded the secondary image.
The system associates with a different
upstream network.
Severity
Informational
Informational
Informational
Warning
Warning
Warning
Informational
Notice
Notice
Notice
Notice
Notice
Error
Error
Informational
Table Continued
55
Need help?
Do you have a question about the 501 and is the answer not in the manual?