Advertisement
Preface
This document is a part of a series of documents detailing the setup and installation process for the IntroSpect
Analyzer and IntroSpect Packet Processor appliances. Refer to these documents in the order listed in
Table 1: Related Documents
Step
Category
1
Quick Start Guide
2
Appliance Setup Guide
3
Configuration Guide
*This document.
**Future document release.
Figure 1 Aruba IntroSpect Packet Processor 2000 – Front View
This Quick Start Guide applies to the following model:
Table 2: IntroSpect Packet Processor 2000 Model
Model
AI-PP-2000
Revision 2 | June 2018
Aruba IntroSpect Packet Processor 2000
Document
Aruba IntroSpect Packet Processor 2000 Quick Start Guide*
Aruba IntroSpect Packet Processor Appliance Setup Guide
Aruba IntroSpect Log Sources Configuration Guide**
NOTE: Log sources are configured on Packet Processor only if
Analyzer is deployed off-premises (such as in a Data Center or in the
Cloud). If Analyzer is deployed on-premise, it is recommended that
log sources be configured directly on Analyzer.
Name
Aruba IntroSpect 5 Gbps Hybrid Packet Log and Flow Data Processor
FPC 2000 Appliance
Quick Start Guide
Table
1.
JSKU #
JZ261A
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Aruba IntroSpect Packet Processor 2000
Summary of Contents for Aruba IntroSpect Packet Processor 2000
-
Page 1: Quick Start Guide
Cloud). If Analyzer is deployed on-premise, it is recommended that log sources be configured directly on Analyzer. *This document. **Future document release. Figure 1 Aruba IntroSpect Packet Processor 2000 – Front View This Quick Start Guide applies to the following model: Table 2: IntroSpect Packet Processor 2000 Model Model... - Page 2 2. Firmly place rails against chassis sides. Align hooks on chassis with holes in rails. 3. Slide inner rail forward until the rails click. 4. Secure the inner rails to the chassis with screws. Figure 3 Attach Inner Rails Inner Rails IntroSpect Packet Processor 2000 | Quick Start Guide...
- Page 3 2. Hang the outer rail rear hooks onto the rear rack slots. 3. Align Packet Processor’s inner rails with the outer rails and slide unit until the locks click. Figure 4 Attach Outer Rails and Install Chassis IntroSpect Packet Processor 2000 | Quick Start Guide...
- Page 4 2. ETH0: Mgmt Port 5. 4 x 1 GbE Mon Ports 3. ETH1: Config Port Figure 5 IntroSpect Packet Processor 2000 – Back View Use the following steps to configure Packet Processor: 1. Connect laptop or computer to Packet Processor's ETH1: Config Port.
-
Page 5: Contacting Support
Email: sirt@arubanetworks.com Revision History The following table provides the revision history of this document. Table 4: Revision History Revision Change Description Revision 2 Added Preface and Revision History. Revision 1 Initial release. IntroSpect Packet Processor 2000 | Quick Start Guide...
Need help?
Do you have a question about the IntroSpect Packet Processor 2000 and is the answer not in the manual?
Questions and answers