Water Heater Installation - Faber FWH SPLASH 301CH Instruction Manual

The installation position of neutral line (blue), live line (brown/red) and earth line
(green/yellow) should be corresponding to the other end on wiring terminals.

3.3 Water Heater Installation

Determine installation position of the unit according to length of power cord / position
①
of air switch (Distance between bottom and floor should be ≥1.6m).
② Make sure the distance between the unit and surrounding wall is not less than 300mm, so
that to have enough space for maintenance purpose.
Determine the position of four fixing screws (attached with the unit), make four holes with
③
corresponding depth in the wall by means of a drill and drive a wall plug into the hole.
④
Drive in the screws on the top and ensure certain distance between screw head and wall
(See Fig.1)
⑤
Mount the unit on the wall and tighten with two screws at bottom, connect the wires and
install top cover with the screws.
3.4 Plumbing Connection
① Water valve with filter should be installed at water inlet of the unit, sealing ring with filter
should be used at end face. (See Fig.2).
Shower flexible tube should be connected with water outlets and shower head separately,
②
attached sealing ring should be used at end face.
!
Metallic / chromed hose and conductive control valve shall not be used.
NOTE
WARNING
7
170
275
(Fig.1)