Table of Contents
Advertisement
Operating Instructions
Now that your spa is installed, you are ready to take advantage of its unique design features—especially the patented
hydromassage performance. Besides being a beautiful addition to your indoor decor or outdoor landscaping, your Jacuzzi
Whirlpool Bath spa will provide you with the ultimate in spa pleasure.
Basic Control Set-Up
The control setup on your spa is designed to give you fingertip control of the heater, air induction, and whirlpool/filter pump
and blower systems of your unit from inside or outside your spa. Follow the basic control setup described on page 9 to
familiarize yourself with the various functions of the control panels located on the top of the spa.
WARNING: Do not turn on power to the spa unless it is filled with water to the normal water level, which is 6" below
the spa rim. If the spa's motor/pump is actuated when there is not sufficient water in the unit, the circulation pump
could be irreparably damaged. Not heeding this caution will nullify the warranty. In addition to damaging the unit,
operating the spa with insufficient water could cause a fire. If an optional timer is used, be sure it is disconnected
when there is insufficient water in the spa.
Initial Instructions
• Using a garden hose, fill the spa with water to the
waterline at 6" below the spa rim.
• At the house service panel, turn ON the circuit breaker
or a switch that controls the electrical service to your
spa. Plug the line cord into a 115VAC 20 AMP
receptacle. (Make sure there is no other appliance on
this circuit.)
• Your spa is provided with a Ground Fault Circuit
Interrupter (GFCI). At initial start-up and at least once
a month thereafter, with power on, push the test button
located on the spa line GFCI. The reset button should
pop out. Push this button in to reset. If the interrupter
fails to operate in this manner, there is a ground
current flowing or a device malfunctioning, indicating
the possibility of electric shock. Turn OFF power and
do not use the spa until the source of the problem
has been identified and corrected.
DETAILS OF GFCI
TEST BUTTON
TRIP INDICATOR LIGHT
OPERATION
RESET BUTTON
T E S T
R E S E T
TEST
RESET
• Lift up the skirt door.
• Locate the HIGH TEMPERATURE SAFETY SWITCH,
which is a button on the end of the heater. Push this
button to be sure it is in the reset mode. The purpose
of this switch is to turn off the heater in case of
excessive heat in the heater housing. If, for some
reason, the switch is tripped, the reset button must be
pushed in the heater to operate again after the water
has cooled to 90°F.
• Close the skirt door.
MODEL Z100 (SHOWN WITH
HEATER CONTROLS EXPOSED.)
WHIRLPOOL JETS
SKIMMER
HEATER
INDICATOR
LIGHT
THERMOSTAT
KNOB
SUCTION
FUNCTION
SELECTOR
SWITCH
HIGH TEMPERATURE
SAFETY RESET BUTTON
7
Advertisement
Table of Contents
