Table of Contents
Advertisement
Inspection and Shipping Claims
Check for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the spa
sustained during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on the outside
of the carton and immediately file a claim with the carrier.
Once the spa has been removed from the carton and before it is permanently installed (see below on this page for
unpacking instructions), check the spa completely for damage. Fill the shell with water and operate the system (see
Operating Instructions) to check for leaks that may have resulted from shipping or handling. All Jacuzzi Whirlpool Bath spas
are factory tested for proper operation and water tight connections prior to shipping. If leaks or other problems are detected,
immediately notify your dealer or Authorized Service Agent, or call 1-510-938-7411 for Warranty Service.
Note: Damage or defects which could have been discovered and repaired prior to installation and which are
claimed after final installation of the spa are excluded from our warranty.
Unpacking
1.
Remove the outer carton by cutting the bands and
lifting the cover and the sides.
2.
Remove the spa cover which is located on top of the
spa. Leave the protective plastic sheet on the spa until
installation begins. This sheet can be reused to protect
the finish from damage and debris during construction.
3.
Lift the spa from the carton (approximate weight 350
lbs.) and set it in place on the patio, deck, or position of
intended use.
4.
If, after having been removed from the carton, the spa
must be turned onto its side to move it, make sure the
surface of the cart or dolly on which it is placed is large
enough to support the entire width of the spa, including
SPA CONTAINED IN SHIPPING
CARTON, SECURED BY BANDS
INSTALLATION
5.
6.
Important: Read all instructions in the Owner's Manual
before beginning installation.
PADDED CART
OR DOLLY
the rim and base of the skirt. The skirt is not designed
to support the product weight and could be damaged if
allowed to do so. For further protection of the skirt,
make sure the surface of the cart or dolly is padded. Do
not allow the spa to rest on the equipment door side.
See illustration at lower right.
Before installation begins, remove the owner's packet
from the accessory package. This package contains
the Warranty Card and the Owner's Manual. Record
the spa serial number on the inside front cover of this
manual and on the warranty card. (See illustration on
page 2 for location of the serial number.)
Place the filter cartridge in a dry place for later use.
SPA RIM
SURFACE MUST SUPPORT
SPA RIM AND BASE SKIRT
SKIRT BASE
3
Advertisement
Table of Contents
