Table of Contents
Advertisement
Equipment Set-Up
1.
Remove the plastic sheet covering the spa. Use care.
Stepping into the spa with shoes will scratch the acrylic
surface.
2.
Remove packing materials from the spa.
3.
Open the door panel.
4.
Pull open the filter housing. To do this, first turn the
locking right at the top of the housing to the left until it
snaps loose. Then, grasping the housing firmly and
rocking it gently side to side, pull downward until the
housing is free from the cap.
5.
Remove the filter cartridge from its plastic bag and
insert it into the filter housing. Then replace the filter
housing, following in reverse order the procedures of
step 4.
6.
Clean the interior of the spa of construction debris.
Remove stubborn stains, paint, or tar with turpentine,
isopropyl alcohol, or paint thinner.
dishwashing detergent on a damp cloth is fine for
cleaning off other dirt. Plaster can be removed by
scraping with a wooden edge. Do not use a metal
scraper, wire brush, or other metal tools, as they will
damage the spa's surface.
7.
On initial start-up, you must purge and sanitize the
system by carefully following the procedure described
here.
• Remove the spa cover completely.
• Close the hose bibb located on the suction tee
plumbing.
• Fill the spa with water to its normal operating level,
which is to the water level indicator mark on the
skimmer/filter frame (6'' below the spa rim).
6
INSTALLATION
A mild liquid
MODEL NUMBER
SERIAL NUMBER
LOCATION
HOSE BIBB
• Insert the line cord plug into the proper receptacle in
a 115 VAC 20 AMP circuit.
• Select WHIRLPOOL on the function selector switch.
• Add 1/4 cup sodium dichlor (a fast dissolving granu-
lar type of chlorine) to the water and let the whirlpool
run for only 15–20 minutes.
• Turn off WHIRLPOOL.
• Unplug the line cord. Open the redwood skirt door.
• Immediately open the hose bibb and drain the spa
completely.
CAUTION: Leave the cover off the spa during this
procedure. Do not use the spa during this procedure.
Drain the spa immediately afterward.
8.
Close the hose bibb and fill the spa with water to
approximately 6" below the spa rim, or to water line
indicator mark on the skimmer frame.
9.
Set the heater thermostat for the maximum tempera-
ture. Close the skirt door.
10. Test the spa for proper operation. (Refer to "Operating
Instructions.")
11. Read the Water Quality section of the "Operating
Instructions" (pages 10–11). Test for water quality,
then add treatment chemicals as needed to ensure
proper levels.
All Jacuzzi Whirlpool Bath spas are factory tested for
proper operation and water tight connections prior to ship-
ping. If leaks or other malfunctions are detected, immedi-
ately notify your dealer or Authorized Service Agent, or call
Jacuzzi Whirlpool Bath 1-510-938-7411 for Warranty Ser-
vice.
LOCATION
FILTER HOUSING
HEATER
GFCI
LOCKING RING
CAP
THERMOSTAT
KNOB
Advertisement
Table of Contents
