Table of Contents
Advertisement
Normal Operation
Whirlpool System
You can enjoy the spa with or without activating the whirlpool. Either way, bathing in your spa can be pleasurable, as
well as therapeutic. After a busy, stressful day, you can look forward to soaking in your spa in still water with no turbulence
and warm water to soothe and relax you.
For a more invigorating spa experience, you can take advantage of the built-in whirlpool system. To do this, select the
WHIRLPOOL mode. Sit or recline in the spa so you are comfortable. Since the four whirlpool jets are adjustable, you can
direct a jet toward any location of your body, particularly toward any area that feels tense or stiff. The warmth of the water
and the stimulating water flow from the jet will pleasantly increase circulation to that area.
HIGH VOLUME ADJUSTABLE WHIRLPOOL JET
TOTAL WHIRLPOOL EFFECT
Special Suction Features
A special feature has been designed into the pump
suction of the spa that automatically reduces the amount of
suction power if the suction fitting is blocked by an object or
by someone using the spa. The bather will know that such
a situation is happening by an additional "gulping" sound in
the system. When this does happen, remove the object,
and normal water flow will be restored automatically.
Note: Refer to Safety Information on the inside front
cover of this Manual.
OPERATION
Silent Air Induction
The intensity of the whirlpool action is determined by
how much air is inducted into the water. You can control
the air flow by adjusting the two air induction control knobs
located on the control panel. For maximum air induction,
turn each control knob fully counter clockwise to the largest
dot. For fewer air bubbles, decrease the amount of air
induction by turning the control knob clockwise. When the
knobs are turned to the smallest dot, only water is being
circulated.
AIR CONTROLS FOR ADJUSTABLE JETS
INCREASE AIR FLOW
(COUNTER CLOCKWISE)
Filtration
When you are ready to leave the spa, select the HEATER/
FILTER mode to maintain the desired water quality and
temperature. If you want to filter the water without heating,
select the FILTER ONLY mode.
The filter pump should be run at least one (1) hour per
day to allow filtration of the water and maintain water clarity.
Select the FILTER mode and run the filter each day. If the
HEATER/FILTER mode is selected and the spa heater
operates at least one hour per day, it will be filtering at the
same time, and it will not be necessary to turn the filter pump
on separately.
DECREASE AIR FLOW
(CLOCKWISE)
9
Advertisement
Table of Contents
