ABB +N5600 Firmware Instructions page 150

150 Parameters
Group
43 Brake chopper
44 Mechanical brake control
45 Energy efficiency
46 Monitoring/scaling settings
47 Data storage
49 Panel port communication
50 Fieldbus adapter (FBA)
51 FBA A settings
52 FBA A data in
53 FBA A data out
54 FBA B settings
55 FBA B data in
56 FBA B data out
58 Embedded fieldbus
60 DDCS communication
61 D2D and DDCS transmit
data
62 D2D and DDCS receive
data
74 ESP control
75 ESP reference setup
76 ESP automatic control
79 Load protection
80 Voltage control
81 Pump cleaning
85 Q-H pump curves
90 Feedback selection
91 Encoder module settings
92 Encoder 1 configuration
93 Encoder 2 configuration
94 LSU control
95 HW configuration
96 System
97 Motor control
Contents
Settings for the internal brake chopper.
Configuration of mechanical brake control.
Settings for the energy saving calculators.
Speed supervision settings; actual signal filtering; general scaling
settings.
Data storage parameters that can be written to and read from
using other parameters' source and target settings.
Communication settings for the control panel port on the drive.
Fieldbus communication configuration.
Fieldbus adapter A configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
Fieldbus adapter B configuration.
Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter B.
Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter B.
Configuration of the embedded fieldbus (EFB) interface.
DDCS communication configuration.
Defines the data sent to the DDCS link.
Mapping of data received through the DDCS link.
Enables ESP function parameters.
Controls frequency/speed reference settings of a drive.
Enables ESP automatic control.
Enables/Disables Underload and Overload protection functions.
Monitors voltage in the motor.
Enables pump cleaning function.
Estimates flowrate of pump curves in ESP application.
Motor and load feedback configuration.
Configuration of encoder interface modules.
Settings for encoder 1.
Settings for encoder 2.
Control of the supply unit of the drive, such as DC voltage and
reactive power reference.
Various hardware-related settings.
Language selection; access levels; macro selection; parameter
save and restore; control unit reboot; user parameter sets; unit
selection; data logger triggering; parameter checksum calculation;
user lock.
Motor model settings.
Page
355
357
361
364
368
371
373
381
382
383
383
384
385
385
393
406
410
418
421
426
429
437
440
446
451
460
463
470
470
473
479
489