Replacing The Lamp; Troubleshooting - Zanussi ZOA35676WK User Manual

CAUTION! Do not use the appliance
without the internal glass panel.
The direction in which you open the
door depends on your oven model.
You open the door from the right side
in some models and from the left side
in others.
1. Press the buttons at the sides of the door trim
(A) on the upper cover and pull it upwards to
remove it.
2. Hold the inner glass B tightly with both hands
and slide it upwards to remove it from its initial
position.
Make sure that you tightly hold glass B to
prevent the glass from falling.

TROUBLESHOOTING

WARNING! Refer to Safety chapters.
A
B
3. Clean the door with a wet sponge and rub it
dry with a soft cloth. Do not use steel wool,
acids or abrasive cleaning agents because they
can damage the surface.
When the oven door is clean, install the glass panel
in the opposite sequence. The screen-printing zone
must face the inner side of the door. Make sure that
after the installation the surface of the glass panel
frame on the screen-printing zones is not rough
when you touch it. Make sure that you put the glass
panel in the rubber distance holders.

REPLACING THE LAMP

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING! Danger of electrocution!
Disconnect the fuse before you
replace the lamp.
The lamp and the lamp glass cover
can be hot.
CAUTION! Always hold the halogen
lamp with a cloth to prevent grease
residue from burning on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
19