Bissell Proheat 2X Revolution 1548 series User Manual page 15

Maintenance:
Replacing Small Belt, Large Belt,
or Brush Rolls (continued)
4
If the belt is broken, gently
remove it from the machine.
6
Stretch the belt
towards the back
Snap the wheel
of the machine with
cover back into
your thumb and
place.
transfer it onto the
metal axle.
8
Replace the brush cover, making sure
the brushes are aligned and the cover
is secure.
NOTE: It is important that the brush rolls
are aligned on both ends of the foot.
5
To replace the
large belt, place it
over the red area
of the large pulley
that is toward
the front of the
machine.
7
Replace smaller-toothed belt by wrapping
around the small metal-toothed pulley, and
the gear at the end of the rear-most brush.
9
Return the belt/brush access plate to
the end of the brush rolls. You should
hear it "click" into place when the
screws align. Using a screw driver,
secure the plate with the three screws.
www.BISSELL.ca
15