Simrad ME70 Installation Manual page 259

Context
The outputs from the three power supply modules are connected to the terminal block on
the left cabinet wall. The output from the +75 VDC power supply is fed through an NTC
resistor. The inputs on the power supplies are not used. These inputs are connected to
Sense
the output terminals.
A PSU Terminal block (on the left side of the Power Supply Unit)
B TRXU Terminal block (on the rear side of each subrack inside the Transceiver Unit)
C Power supplies
D The cables from the TRXU Terminal block are connected to the Power Connector Panel
on the rear side of the TRXU subrack.
E The power cables are run in steel conduits.
F This symbol means that the terminals are connected with a conductive rail.
345737/C
Setting to work
257