Scanning Operation - Yaesu FTA-250L Operating Manual

Scanning Operation

When in COMM mode (
scanning searches for a frequency or memory chan-
nel that is receiving a signal.
1. P r e s s a n d h o l d t h e
[ DWN ] or [ UP ] key to
start scanning.
z Press and hold the [ DWN ] key à Scan to lower
frequencies.
Press and hold the [ UP ] key à Scan to higher
frequencies
z When shipped from the factory, scanning in the
memory mode will scan only the current group, but
scanning can be reset to scan the memory channels
registered in all groups. For details, refer to "MEMORY
SCAN TYPE" on page 24.
z Scanning may also be started by pressing the [FUNC]
key, and then pressing the [DWN](
z Scanning will stop temporarily when a signal is
received, and the frequency display flashes.
2. To stop scanning, press any key on the keypad.
18
) or MEMORY mode (
) key.
When weather alert function is ON, scan speed is
delayed because scanning also monitors the last used
) ,
weather channel for the emergency alert signal. Weather
alert function is OFF in the factory default.
Example: When the last weather channel is 162.400
MHz ( WX02 ) , and the frequency at which
scanning is started is 118.000 MHz.
118.000 à 162.400 à 118.025 à
à 162.400 à 118.050 à 162.400 ...
The frequency of the weather channel is not displayed
during scanning.
FTA-250L O M
perATing AnuAL