Process Group Configuration; Setting The Recording Parameters - ABB SM2000 User Manual

Advanced Videographic Recorder
SM2000

4.5 Process Group Configuration

Fig. 4.8 Selecting Process Group Configuration
Note. If 'Number of groups' is set to '1' (see Section 4.4.1, page 52), only one Process Group icon and associated Channels
icon is displayed in the main configuration window.

4.5.1 Setting the Recording Parameters

Note. Parameters marked
64
B
are displayed only if Basic Configuration is selected – see Table 4.1 and Section 4.4.1.
Process Group 1
or
Process Group 2
Enter the process group tag (maximum 20 characters) that
appears in the title bar when any operator views from that group
are displayed.
Note. Each process group tag
Select a signal source to enable/disable recording of all
B
channels in the current Process Group. Refer to Appendix A,
page 108 for a description of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to
active) enables recording. A falling edge (active to inactive)
disables recording.
Enabled
4 CONFIGURATION
be unique.
must
Disabled
IM/SM2000 Issue 11