SM3000
Multipoint Videographic Recorder
6.5 Process Group Configuration
Fig. 6.11 Selecting Process Group Configuration
Note. The number of Process Groups and associated channel options displayed depend on the number of Process Groups
selected during common configuration setup – see Section 6.4.1, page 61.
6.5.1 Setting the Recording Parameters
76
Process Group 1
or
Process Group 2
or
Process Group 3
(see Note below)
Enter the process group tag (maximum 20 characters) that
appears in the title bar when any operator views from that group
are displayed.
Note. Each process group tag must be unique.
Select a signal source to enable/disable recording of all
channels in the current Process Group. Refer to Appendix A on
page 129 for a description of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to
active) enables recording. A falling edge (active to inactive)
disables recording.
Enabled
6 Configuration
Disabled
IM/SM3000–EN Rev. L