Tektronix THS3014 Security Instructions
Ths3000 series
Hide thumbs
Also See for THS3014:
- Technical reference (45 pages) ,
- User manual (130 pages) ,
- Installation and safety instructions (94 pages)
Related Manuals for Tektronix THS3014
Summary of Contents for Tektronix THS3014
- Page 1 THS3000 Series Oscilloscopes Declassification and Security Instructions www.tektronix.com *P077060500* 077-0605-00...
- Page 2 Copyright © Tektronix. All rights reserved. Licensed software products are owned by Tektronix or its subsidiaries or suppliers, and are protected by national copyright laws and international treaty provisions. Tektronix products are covered by U.S. and foreign patents, issued and pending. Information in this publication supersedes that in all previously published material.
- Page 3 Clear and Sanitize Procedures If you have data security concerns, this document helps you to sanitize memory devices in the THS3000 Series Oscilloscopes. If you have any questions, contact the Tektronix Technical Support Center at http://www.tektronix.com/support. Products The following Tektronix products are covered by this document:...
- Page 4 Tektronix. Calibration constants stored in D5000 and D5002 can be read using special remote interface commands only available for internal use by Tektronix. The calibration constants are generated when the oscilloscope is sent through its calibration process and are fundamental to the oscilloscope operation.
- Page 5 Clear and Sanitize Procedures 5. Press F2 – SELECT ALL. 6. Press the Enter button. 7. Press F4 – YES to confirm the Clear action. To clear all data stored in SRAM, disconnect the oscilloscope from all voltage sources, open the battery door at the rear panel, and lift the battery out of the instrument.
Need help?
Do you have a question about the THS3014 and is the answer not in the manual?
Questions and answers