Installation; Location - Sanitron S2400C Installation Operation & Maintenance

(Water Quality Continued from Page 4) Effectively treating water with higher concentration levels than listed on (Table 1 -
Maximum Concentration Levels on Page 4) can be accomplished, but may require added measures to improve water quality to
treatable levels. If, for any reason, it is believed the ultraviolet transmission is not satisfactory, contact the factory.

INSTALLATION

L
OCATION
1. The water purifier is intended for indoor use only. The water purifier is designed to mount horizontally. The water purifier
should be protected from the elements and from temperatures below freezing. The ambient temperature, in the area
surrounding the water purifier, should be between 35
2. Electrical power supplied to the water purifier MUST match power requirements listed on the water purifier. Use of a
voltage surge protector is recommended.
3. CAUTION: Plug water purifier only into an approved ground fault circuit interrupt (GFCI) receptacle.
4. The water purifier should be located in a dry, well-lit area, which provides enough room to perform routine maintenance.
This includes a minimum distance of one chamber length from the wiper end, to allow for cleaning and/or the changing
of the lamp and quartz sleeve as well as a minimum of 6" on the opposite end of the water purifier. Minimum
clearance to floor 18''.
5. The water purifier should always be located closest to the point of use. This reduces the chance of the purified water being
re-contaminated by bacteria in the water distribution system after the water purifier.
6. CAUTION: As with any water handling device, the water purifier should be located in an area where any possible
condensation or leakage from the water purifier, any purifier accessory and/or plumbing will not result in damage to the
area surrounding the water purifier. For added protection, it is recommended that a suitable drain pan be installed under the
purifier. The drain pan must be plumbed to an adequate, free flowing drain to prevent water damage in event of a leak. There
are numerous leak detection/flood stop devices, available on the market today, designed to stop flow of water, reducing the
chance of water damage due to leakage. For more details regarding leak prevention and/or limiting damages due to leaks
please contact factory.
7. The water purifier should be located after all other water devices, such as De-ionizers, Water Softeners, Carbon Filters, Pre-
Filters, Reverse Osmosis, Pressure Tanks, and Pumps. This reduces the chance of the purified water being re-contaminated
by bacteria in any of these units.
Figure 1 - SANITRON
o o
F and 100 F.
®
Drawing (S5,000C shown) with options and extra components
* Extra Components (not included with SANITRON ®
)
5