Advertisement

U LT R AV I O L E T WAT E R P U R I F I E R S
Models S2400C, S5,000C - S25,000C
Read and Follow All Safety Instructions. Save These Instructions.
SINCE 1963
Manufacturers / Engineers / Sales / Service
Germicidal Ultraviolet - Equipment & Lamps
Extensive Product Information Available at:
ultraviolet.com
Document No. 98-1132D7 • October 2014 • ©2014 Atlantic Ultraviolet Corporation
High Capacity Systems
Installation,
Operation
& Maintenance
®
®
1

Advertisement

Table of Contents
loading

Summary of Contents for Sanitron S2400C

  • Page 1 ® U LT R AV I O L E T WAT E R P U R I F I E R S Models S2400C, S5,000C - S25,000C High Capacity Systems Read and Follow All Safety Instructions. Save These Instructions. Installation, Operation &...
  • Page 2: Table Of Contents

    These instructions generally describe the installation, operation and maintenance of the SANITRON Model S2400C line of water purifiers. Models S5,000C and S10,000C through S25,000C High-Capacity Systems utilize the Model S2400C single lamp water purifier in various configurations. Questions that are not specifically answered by these instructions should be directed to the Factory.
  • Page 3: Safety Warnings

    SAFETY WARNINGS • All personnel should be alerted to the potential hazards indicated by the product safety labeling on this unit. • The following conventions are used to indicate and classify precautions in this manual and on product safety labeling. Failure to observe precautions could result in injury to people or damage to property.
  • Page 4: Product Application

    European Norm (EN) standards to which these units were tested, to demonstrate conformity. RINCIPLE OF PERATION The SANITRON ® design has been carefully conceived to provide adequate germicidal dosage throughout the disinfection chamber. The dosage, as it applies to ultraviolet disinfection, is a function of time and the intensity of ultraviolet radiation to which the water is exposed.
  • Page 5: Installation

    Filters, Reverse Osmosis, Pressure Tanks, and Pumps. This reduces the chance of the purified water being re-contaminated by bacteria in any of these units. Figure 1 - SANITRON ® Drawing (S5,000C shown) with options and extra components * Extra Components (not included with SANITRON ®...
  • Page 6: Installation

    SAFETY EQUIPMENT REQUIRED TO PERFORM TASK Remove water purifier from shipping carton. Inspect water purifier, power cord and plug for damage. Do not operate if there is any damage to the purifier, power cord or plug. SANITRON ® Model S2400C is shipped with the lamp packed separately.
  • Page 7: Recommended Options

    The water purifier must be connected to the cold water line only. Installation requires that a 5-micron sediment filter or finer be installed, in line, prior to the water purifier. The sediment filter will stop or trap large particulates from entering the water purifier. Particulates may cause damage to the quartz sleeve, as well as interfere with the purifier’s ability to disinfect the water.
  • Page 8: Maintenance

    The time delay mechanism is used in conjunction with, and is electrically connected to the Solenoid Valve. Wall Mount Kit: Model S2400C Stainless steel wall brackets provide quick and easy installation and professional finish. Pre-drilled and ready to install. Optimizes free air circulation to cool ballast housing.
  • Page 9: Disposal Of Mercury Added Lamp

    ISPOSAL OF ERCURY DDED AMPS Germicidal ultraviolet lamps, like standard fluorescent lamps contain small amounts of mercury. Mercury added lamps should not be placed in the trash. Dispose of properly. For further information regarding the disposal and recycling of lamps containing mercury, along with Federal and State requirements visit http://www.lamprecycle.org. Product Data ®...
  • Page 10: Lamp Installation Or Replacement

    NSTALLATION OR EPLACEMENT Figure 5 - Lamp Replacement Step 2 - Remove End -Cap Step 3 - Withdraw Lamp Step 4 & 5 - Remove Sockets Step 6 - Remove Lamp SAFETY EQUIPMENT REQUIRED TO PERFORM TASK WARNING: Disconnect power to water purifier. Remove both EASY-OFF end caps by pulling each cap off static gland nut.
  • Page 11: Quartz Sleeve Installation Or Replacement

    UARTZ LEEVE NSTALLATION OR EPLACEMENT Figure 6 - Quartz Sleeve Installation or Replacement Step 4 - Remove Gland Nuts Step 5 - Remove Washer & O-Ring Step 6 - Remove Quartz Sleeve SAFETY EQUIPMENT REQUIRED TO PERFORM TASK WARNING: Disconnect power to water purifier. 2.
  • Page 12: Replacement Of Broken Quartz Sleeve

    • Model S2400C the ballast housing is mounted to the purifier chamber using four (4) 1/4”-20 x 3/8” long hex head bolts. Using a 7/16” wrench or an adjustable wrench, carefully remove the four (4) bolts with the lock and flat washers, from along the top of the ballast housing, and set aside.
  • Page 13: Optional Guardian

    12. Re-install o-rings, Teflon ® washers, and static gland nuts. Be sure o-rings are placed on quartz sleeve before Teflon ® washer. Tighten static gland nuts firmly by hand only, DO NOT USE HAND TOOLS. Tightening with hand tools is likely to cause quartz sleeve to break.
  • Page 14: Troubleshooting

    Optional Accessories Available For: operation at 120v 60Hz or 220v 50Hz. Please specify. Guardian™ Ultraviolet Monitor - Analog/Digital S2400C, S5,000C - S25,000C Not all options may be available Sentry™ Safety Sensor S2400C, S5,000C - S25,000C for all models, consult factory for availability Steralert™...
  • Page 15: Technical Specifications

    TECHNICAL SPECIFICATIONS Table 4 - Technical Specifications Model: S2400C S5,000C S10,000C S15,000C S20,000C S25,000C Flow Rate (GPM): Flow Rate (GPH): 2400 5000 10000 15000 20000 25000 Inlet\Outlet Size: 2”m NPT 2”m NPT 2”m NPT 2”m NPT 2”m NPT 2”m NPT Number of Lamps: Lamp Model No.:...
  • Page 16: Replacement Parts

    REPLACEMENT PARTS ® SANITRON S2400C ODEL Figure 10 - Exploded View S2400C...
  • Page 17: Replacement Parts

    Table 5 - Replacement Parts S2400C 120v/60Hz 220-240v/50Hz CE/RoHS 220-240v Item No. Description Part Number Part Number Part Number Easy-Off End Cap 25-0389A 25-0389A 25-0389A Rubber O-Ring, Static Gland 00-0085A 00-0085A 00-0085A Lead Wire & Socket 05-2400A 05-2400A 05-2400A Static Gland Nut...
  • Page 18: High Capacity Systems

    ® SANITRON HIGH CAPACITY SYSTEMS IMENSIONAL Figure 11 - S2400C& S5,000C Dimensional Data...
  • Page 19: Dimensional Data S10,000C, S15,000C, S20,000C & S25,000C

    IMENSIONAL Figure 12 - S10,000C, S15,000C, S20,000C, S25,000C Dimensional Data...
  • Page 21: Maintenance Notes

    MAINTENANCE NOTES...
  • Page 22 MAINTENANCE NOTES...
  • Page 23: Maintenance Notes

    MAINTENANCE NOTES...
  • Page 24: User Assistance

    This manual Fax: 631.273.0771 installation or use of this unit, contact describes the installation, operation E-mail: info@ultraviolet.com and maintenance of the SANITRON ® our offices, weekdays between 8:30 am Website: www.ultraviolet.com and 5:00 pm Eastern Time, at: Ultraviolet Water Purifiers www.buyultraviolet.com...

This manual is also suitable for:

S15,000cS20,000cS10,000cS5,000cS25,000c

Table of Contents