List Of Safety Marks Used On The Machine - NTC RZ113 Operation Manual

Asphalt and concrete cutters
1.8.

List of safety marks used on the machine

In accordance to requirements of law no 22/1997 Sb. About technical requirements on products in valid version,
there are stickers of safety marks and informative symbols placed on the machines (types – see point 2.1). Types of
the stickers are explained further, explanation is attached to each symbol.
Combined stickers of safety symbols according to ČSN
1.
ISO 3864 (symbol no. B.2.5, B.3.1 and NB. 2.26), symbol
according to CS ISO 6405-1 (symbol no, 7.28) and
information for operating the machine.
Safety symbol no. B.2.5 orders the operator to use ear
protection.
Symbol no. 7.28 orders the operator to read the manual
prior to starting the operation.
Safety mark, symbol no. NB.2.26 orders the operator to
use protective gloves during the operation to reduce
vibrations.
Safety mark, symbol no. B.3.1 (exclamation mark) warns
the operator from the danger risk.
Information for the operator regarding repair, cleaning or
adjusting the machine.
2.
Symbol no. 7.23 according to CSN ISO 6405-01 (sticker
shows spots which should be greased according to
operation manual)
3.
Symbol no. 8.1 according to CSN ISO 6405-01 (sticker
show spot where engine oil drain bolt is located)
4.
Safety symbol no. B.3.1(exclamation mark) warns the
operator from danger risk.
Symbol shows blade and the shoe, which means: PAY
ATTENTION FOR LEG INJURY FROM ROTATING
CUTTING BLADE.
5.
Symbol no. 7.25 according to CSN ISO 6405-01 (symbol
shows machine lifting points)
Page 9
Operation manual
issued 01/2017