Operation Of The Machine; Maintenance And Service; Transport And Storage - NTC RZ113 Operation Manual

Asphalt and concrete cutters

1.1.4. Operation of the machine

Before starting:
1. Check the machine thoroughly, repair all
failures before starting the engine. If the
failures cannot be repaired at the jobsite, do
not operate the machine.
2. Check the fuel system for leaking. Dripping
fuel poses fire hazard.
Starting and operation:
3. When starting the engine, take stable
position and held the grip firmly.
4. The controls must be in good order.
5. The operator must not leave from his
position when the engine is running.
6. Stop the engine before interrupting the
work. When parking the machine, secure it
from falling.
7. Stop the engine before refueling. Avoid
contact between fuel and hot parts of the
engine. Let the engine to cool down first.
8. Keep the fuel tank tightly closed. Close the
fuel tap when not in operation. Drain the
fuel before transporting the machine for
longer distances.

1.1.5. Maintenance and Service

1. Check the technical condition of the
machine regularly, mainly the protective and
operation parts. Arrange any possible
defects repair.
2. Only qualified personnel is allowed to do
service works.
3. Service works should be done only in
workshops, where ecological rules and work
safety are ensured. If machine needs to be
serviced at the job site, make sure not to
collide with other machines or equipment. It

1.1.6. Transport and Storage

1. Machine can be transported only by
wehicles and
corresponding capacity.
2. When using a crane corresponding
safety rules must be applied. To be done
only by authorized personel.
3. Use the lifting point marked at the
machine.
page 6
equipments with
Operation manual
DANGER! Leaking fuel tank and distribution
may cause explosion. Replace these parts
immediately if damaged.
Jobsite:
9. No bystanders are allowed within the
operational range of the machine. Especially
children should be kept in safe distance.
10. Do not operate the machine in areas with
explosion danger.
11. If operated in closed spaces (halls, tunnels),
there should be
ventilation.
12. Held and guide the machine with high care
in order to avoid hands injury caused with
contact with an obstacle.
14. Do not smoke, do not use naked flame. Do
not work close to flammables or in
explosion danger areas.
15. Avoid touching hot parts. The exhaust
silencer and other parts of the engine are
very hot during operation and touching them
can cause serious burns.
is prohibited to service the machine at places
where ecology, work safety could be
endangered, for example by other equipment
operation, landslide, etc.
4. Service works can be done only when the
engine is switched off. If it is necessary to
start the engine, pay attention.
5. Use only genuine spare parts.
6. Any modifications can be done only with
manufacturer prior approval.
4. When loading by hand cooperation of
more people is needed, pay attention to
max. allowed carrying capacity of a
worker.
5. Secure the machine to prevent damage
or overturning.
6. Machine must be transported in upward
position.
ensured sufficient
issued 01/2017