Identification; Engine Identification; Prior To Starting; Check - Oil Level - NTC RZ113 Operation Manual

Asphalt and concrete cutters

2.3. Identification

For communication with the manufacturer (i.e.
for warranty claims, service requests, spare parts
ordering) always report exact model and serial
number of your machine.
These data are stamped on the machine decal.
2.4.

Engine Identification

In case of problems related to the engine report
also engine type and serial number. This number
is stamped on the engine block (HONDA)
have doubts, contact the manufacturer.
3.

PRIOR TO STARTING

- Check whether the engine leaking (leaks) oil. In case of defect, contact an authorized service
center or manufacturer.
- Bolted connections for loop control of depth of cut and the matrix arm guidance are glued.
Screws at the pulleys, the drive chassis are tight and prescribed the query moment. We therefore
recommend against any potential activity associated with permitting and tightening of joints, and
contact information to an authorized service center or manufacturer.

3.1. Check - Oil Level

It is highly recommended to check regularly the
engine oil level even at machines equipped with
the oil sensor.
In case of a machine without the oil sensor,
daily check is a must.
Clean the filling hole before checking or adding
oil. Wipe dry the dipstick and immerse it in the
oil without screwing it in.
If necessary, add specified sort of oil up to the
upper mark.
Page 12
Fig. Machine decal
Fir. Location of the S/N on engine HONDA
If you
NOTE :
Operation with insufficient oil level may cause
serious damage to the engine.
Oil level checking procedure:
Have the machine at even surface. Remove the
filler cap, the oil comes out of the drain hole
slightly when the oil level is correct.
Check the engine oil level daily!
Operation manual
issued 01/2017