Table of Contents
Advertisement
•
•
•
6.
Run Diagnostics
Use the OCLC Check CD Program 3.00 to test
your
Hitachi CD drives.
This program tests all Hitachi CD drives chained to the CD controller
board. Drives are tested
in
sequential order for
Select,
Reset, Seek, and
Read functions
. However,
since screen
messages
scroll
rapidly off the
display during execution,
you
may want to print the
screen
displays on
a parallel printer so that
you will
have time to
analyze
the test
results.
1
Reboot
your
workstation
with
MS-DOS 3.1 or later.
2
Insert a
compact
disc that
contains
data
in
the Hitachi CD drive
that
you
are
testing.
3
Insert the Check CD Program 3.00 diskette
in
drive A of
your
work-
station;
and,
from the DOS prompt, typeA:CKCD and press
<Enter>.
The introductory
screen
appears and confirms that
you are
using
Check CD Program
3.00 (CKCD
.EXE VER.
3.00).
If
the VER number
is not 3.00
,
contact OCLC
User
&
Network
Support,
and request
Check CD Program
3.00.
4
Press the space bar to continue. The controller
address
menu appears
(see
fig.
3).
If your Hitachi controller board has BASE ADDRESS selection juMpers,
indicate uhich addresses are selected by the juMper.
A.
Addresses 2BB-2BF
B.
Addresses 22B-22F
C.
Addresses 248-24F
D.
Addresses 268-26F
E.
Addresses 388-38F
F.
Addresses 328-32F
G.
Addresses 348-34F
H.
Addresses 368-36F
Hitachi norMally ships the controller for base address 388H.
Enter the letter for the desired address setting.
Fig. 3. Controller Address Menu
5
Select the
appropriate address setting.
If
your CD
is set
for
300,
selectE;
if
your
CD
is set for
200,
selectA .
Hitachi 3700 CD Drive Installation Instructions
9
Advertisement
Table of Contents
