Resolving Other Basic - Hitachi 3700 Installation Instructions Manual

•
•
•
..
3
Insert a straightened paper clip into the Manual Emergency Eject
Hole, and push it straight in about . 5 inch (13 mm). The drive
ejects the CD caddy .
I
BUSY
•
PHONES
•
I
VOLUME EJECT
-
C i)
c::::::::JI t::::=:l
ft
Dust-proof Label /
[!)
Straightened paper clip
Minimum straight length: 40mm
Diameter: 1-1.8mm
Fig. 5. Manual Emergency Ejection
4
Remove the paper clip by carefully pulling it straight out.
5
Replace the dust-proof label over the Manual Emergency Eject Hole .
6
Turn the drive on and resume your tasks .
10.2 Resolving Other Basic Problems
If you have a problem other than the CD caddy sticking, follow these
steps until you resolve the problem.
1
Verify that all cables are properly connected and that all plugs are
firmly seated in their sockets.
2
Verify that the DIP switch settings on the OCLC I/0 Board are cor-
rectly set.
3
Verify that the I/0 Board synchronous port address is set correctly
in PASSPORT Software :
• If you use an M300 I/0 Board without DIP switches, the ad-
dress should be 300.
• If you use an l/0 Board other than an M300 I/0 Board without
DIP switches, the address should be 210 .
4
If one of the following error conditions or messages occurs with
the Check CD Program 3 .00 take the action indicated:
System lock up-Cold boot (by turning your workstation off and
then on again after 10 seconds) . If this does not resolve the prob-
lem, make sure that your synchronous port address on the OCLC
I/0 Board is set at 210H and your CD controller board and CD
drives are properly installed.
"Bad Command"--Check the DOS path and command syntax .
"Invalid Parameter"--Check the DOS path and command syntax.
Hitachi 3700 CD Drive Installation Instructions 15