Safety Precautions; Troubleshooting - Samsung CY-SWC1000A User Manual

to the user manual of the product.
ˆ y Be sure to use the adapter supplied with the glasses. Using an adapter that is not
supported may damage the glasses or cause the glasses to malfunction.

5. Safety Precautions

The following is to prevent injury to users and damage to property. Make sure to carefully read
and observe the following.
[ Warning
● Do not use the product for a purpose other than charging the devices specified in this user manual.
Do not throw the product or use the product as a pillow or a stand for another object.
● This product artificially generates a magnetic field in charge ready mode. Although this product
does not affect general electric appliances, do not place the product near electronic equipment
sensitive to magnetic fields, especially life sustaining equipment.
● Do not place the product in a location exposed to direct sunlight, heat or moisture. This may result
in a malfunction or fire.
● Do not apply pressure or impact or drop this product. This may result in a malfunction.
● Do not spray water or cleaning agent directly onto the product. Failing to do so may cause a fire or
electric shock, damage the appearance or erase the print on the product.
● Do not apply chemicals containing alcohol, solvent or surfactant such as wax, benzene, thinner,
mosquito repellent, air freshener, lubricant or cleaning agent to the product. This may result in the
exterior becoming discolored or cracked, or the print may be erased.
Ferrite Core
y y Ferrite Core for Power Cord: The ferrite cores are used
to shield the cables from interference. When connecting
the ferrite core to a cable, open the ferrite core and clip
it around the cable near the plug as shown in the figure.
y y A One ferrite core should be no more than 4 inches
from the end of the cord that is inserted into the AC
outlet.
English-2
CY-SWC1000A_Na_L16.indb 2

6. Troubleshooting

If this symptom appears take the following countermeasure.
The charging function Check if the top power LED is green and the blue front LED
does not work. blinks slowly.
The top power LED or
Check if the AC adapter is connected properly and the DC
the front blue LED is not
power jack is connected properly.
illuminated.
The charger temporarily entered overload protection mode.
The top LED blinks at a
Remove the 3D glasses from the wireless battery charger.
regular interval.
Next, disconnect and re-connect the DC jack.
7. Product Specifications (Model: CY-SWC1000A)
Operating Type Energy transfer through 13.56MHz magnetic resonance.
Dimensions (D x H)
Weight
AC Adapter Input
Power Supply
Cradle Input
Standby Mode
Power Consumption
Charging Mode
Operating Temperature
Operating Humidity
Operating Conditions
Storage Temperature
Storage Humidity
Charge Time 3D glasses
※ The charging time mentioned above is based on the glasses being placed within the
recommended area of use as indicated herein. Charging may take longer if the glasses
are outside of the recommended area.
188 x 115 mm (7.4 x 4.5 in )
Approximately 524 g
AC 100~240V 50/60Hz
DC 12V
0.5W
8.9W
10°C ~ 40°C (50°F ~ 104°F)
10% ~ 80%, non-condensing
-20°C ~ 45°C (-4°F ~ 113°F)
5% ~ 95%, non-condensing
2~3 Hours (charging individually)
2011-02-17 오후 1:19:07