Operation; Ac Current Measurements - Test Equipment Depot 9305 Instruction Manual

Operation

NOTICES: Read and understand all warning and precaution
statements listed in the safety section of this
operation manual prior to using this meter. Set the
function select switch to the OFF position when the
meter is not in use.

AC Current Measurements

WARNING: Ensure that the test leads are
disconnected from the meter before making current
clamp measurements.
1. Set the Function switch to the 400 or 40A range.
2. If the range of the measured is not
known, select the higher range
first then move to the lower
range if necessary.
3. Press the trigger to open jaw.
Fully enclose one conductor
to be measured.
The clamp meter LCD will display the reading.
DC/AC Voltage Measurements
1. Insert the black test lead into the negative COM terminal
and the red test lead into the positive V terminal.
2. Set the function switch to the V position.
3. Select AC or DC with the MODE button.
4. Connect the test leads in parallel to the circuit under test.
5. Read the voltage measurement on the LCD display.
6