Secced SC-Video-10/100VP Operator's Manual page 27

Adjusting the spreader
NOTE:
Always use the spreader where possible as this increases rigidity of the tripod. At the
full extension of the spreader and with all legs fully retracted, the tripod can be used
at its lowest operating height. Although tripods can be set lower than this without
spreader, it is NOT recommended as the tripod geometry become unstable.
NOTE: Floor spreaders protect floors and carpets as well as protecting the tripod legs sinking
into soft ground and should be used at all time. If the floor spreader cannot be used,
use secnovo rubber feet and middle-level spreader.
Once the tripod is installed, the floor spreader can be adjusted as follows:
Slacken three clamping knobs (26) on spreader.
Set legs of tripod to required position and height and ensure they are locked.
Once the tripod is positioned correctly, apply three clamping knobs. The spreader does not have
to be removed when collapsing the tripod.
Fig 18
Release the clamping knob (Anti-clockwise)
Tighten the clamping knob (Clockwise)
(26)
25