Servicing; Routine Maintenance; Cleaning - Secced SC-Video-10/100VP Operator's Manual

Routine maintenance

During use, check the following
Check the condition of the clamping washer (15) and the pan bar clamping sleeve (13),
replace them if the teeth of the clamping washer and clamping sleeve are almost weared away.
Check the effectiveness of the slide plate, add some grease lubricant onto the slide plate if
slide plate do not move when tilting to +45° and -45° (as shown in Figure 10).
Check the effectiveness of the pan and tilt drag controls. Repair as necessary.
Check the effectiveness of the pan and tilt brake knob. Repair as necessary.
No further routine maintenance is required.

Cleaning

During indoor use the only cleaning required should be a regular wipe over with a lint-free cloth.
Dirt accumulated during storage may be removed using a semi-stiff brush. Particular attention
should be given to the leveling bowl and mounting face of the head.
Use out-of-doors under adverse condition will require special attention. Salt spray should be
washed off with fresh water at the earliest opportunity. Sand and dirt acts as an abrasive and
should be removed using a semi-stiff or vacuum cleaner.
NOTE:
Use only detergent-based cleaners. DO NOT use solvent- or oil-based cleaners,
abrasives or wire brushers to remove accumulations of dirt, as these damage
the protective surfaces.
Fig 10
14

Servicing