Mic Gain And Line Gain(10) - Ten-Tec Argonaut VI 539 User Manual

Argonaut VI

Mic Gain and Line Gain(10)

Be sure TMB switch is in the Bottom position
and the Argonaut VI is in either LSB or USB
mode. Press USR (MOD) button until you
see (mI CgAIn) on the front display. Use the
VFO knob to adjust the microphone gain until
the ALC light flickers on voice peaks when
speaking into the microphone. This is the
LED light within the Ten-Tec logo. Once set
just press the USR (MOD) button once more
to exit. To set the LINE GAIN press and
hold the USR (MOD) button down until the
screen displays (LinEgAIn) and like before
adjust the level with the main VFO
knob.Once the line gain and microphone gain
have been established both levels will remain
unless a master reset is done.
between microphone input and Auxilliary
Line input simply press the USR (MOD)
button once for microphone gain or hold
down this button for Line Gain.
If other microphones are used with the
Argonaut VI, which may need more gain,
Ten-Tec has provided a hardware microphone
gain control, See Figure 2.4-3. Setting the
microphone gain around 35-50 and then
adjusting the trim pot on the right side of the
transceiver until proper ALC is accomplished
will help make the Argonaut VI flexible with
a multiple of different style microphones.
539 / Argonaut VI Users manual
Part #74479
Printed in USA
2
1 3
Figure 2-1 539 Front Panel- (with indexes)
To toggle
Release 0.10 – November 13, 2012
15
7 8
5
4
Figure 2.4-3 HW Mic G ain Control
9
10
6
H a rd w a r e M i c
G a in A d j u s t
P O T