Table of Contents
Advertisement
DSR changed: When DSR (Data Set Ready) signal changes,
CTS changed: When CTS (Clear To Send) signal changes,
Port connected: In TCP Server Mode, when the device accepts
Port disconnected: In TCP Server/Client Mode, when the
To enable activate the notification, specify the event type and the
notification methods. The details of SNMP trap Server, Email SMTP
server, or Log server IP should be configured first properly in device
"Configuration" "Management".
indicating
that
equipment is powered off, the event will be
triggered.
indicating that the transmission between
computer and DCE can proceed.
an incoming TCP connection, this event will be
trigger. In
device has connected to the remote host, this
event will be trigger. In Virtual COM Mode,
when Virtual COM is ready to use, this event
will be trigger.
device lost the TCP link, this event will be
trigger. In Virtual COM Mode, When
Virtual COM is not available, this event will
be trigger.
29
the
data
TCP Client
Mode, when the
communication
Advertisement
Table of Contents
