Table of Contents
Advertisement
You can define 4 delimiters (00~FF, HEX) for each way and until the
delimiters are received, the data will not transmit success.
"Flush Ethernet to Serial Data Buffer After" is for counting the flush
times out of data transmitted between Ethernet and Serial.
"Force TX interval time" is for specifying the timeout when no data
has been transmitted and the timeout is reached or TX buffer is full
(4K Bytes), the queued data will be sent. If you want to disable and
the parameter is setting "0". (factory default)
Service Mode
UDP Mode
When device is configured as TCP Server, it gives the connected
serial device a unique IP : Port address on a TCP/IP network that it
can be accessed by other host on the network. Device as TCP
Server waits passively to be contacted by the host computer,
allowing the host computer to establish a connection with and get
data from the serial device. This operation mode supports up to 5
simultaneous connections, so that multiple hosts can collect data
from the same serial device at the same time.
27
Advertisement
Table of Contents
