Yamaha TRACER MT09TRA Owner's Manual page 74

Periodic maintenance and adjustment
1
2
3
1
4
5
1. Torque wrench
Tightening torque:
6
Oil filter cartridge:
17 N·m (1.7 kgf·m, 12 lb·ft)
7
8. Install the engine oil drain bolt and
its new gasket, and then tighten
8 the bolt to the specified torque.
Tightening torque:
9
Engine oil drain bolt:
43 N·m (4.3 kgf·m, 31 lb·ft)
10
9. Refill with the specified amount of
the recommended engine oil, and
11
then install and tighten the oil filler
cap.
12
Recommended engine oil:
See page 8-1.
Oil quantity:
Oil change:
2.40 L (2.54 US qt, 2.11 Imp.qt)
With oil filter removal:
2.70 L (2.85 US qt, 2.38 Imp.qt)
TIP
Be sure to wipe off spilled oil on any
parts after the engine and exhaust sys-
tem have cooled down.
NOTICE
In order to prevent clutch slip-

page (since the engine oil also
lubricates the clutch), do not
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
Make sure that no foreign mate-

rial enters the crankcase.
10. Start the engine, and then let it idle
for several minutes while checking
6-13
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
TIP
After the engine is started, the engine
oil level warning light should go off if the
oil level is sufficient.
NOTICE
If the oil level warning light flickers
or remains on even if the oil level is
ECA11621 correct, immediately turn the engine
off and have a Yamaha dealer check
the vehicle.
11. Turn the engine off, wait a few min-
utes until the oil settles, and then
check the oil level and correct it if
necessary.
ECA10402