Table of Contents
Advertisement
Instrument and control functions
lights, push the switch in after it has re-
1
turned to the center position.
2
Horn switch "
"
Press this switch to sound the horn.
3
Stop/Run/Start switch "
4
To crank the engine with the starter, set
this switch to "
", and then push the
5
switch down towards " ". See page
5-1 for starting instructions prior to
6
starting the engine.
Set this switch to "
" to stop the engine
in case of an emergency, such as when
7
the vehicle overturns or when the throt-
tle cable is stuck.
8
Hazard switch " "
9
With the key in the "ON" or "
tion, use this switch to turn on the haz-
10
ard lights (simultaneous flashing of all
turn signal lights).
11
The hazard lights are used in case of
an emergency or to warn other drivers
when your vehicle is stopped where it
12
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
EAU12501
gine not running, otherwise the bat-
tery may discharge.
EAU54212
/
/ "
Menu switch "MENU"
This switch is used to perform selec-
tions in the setting mode display of the
multi-function meter unit.
See Multi-function meter unit on page
3-6 for detailed information.
Select switch "
This switch is used to perform selec-
tions in the information display and set-
EAU12735
ting mode display of the multi-function
meter unit.
" posi-
See Multi-function meter unit on page
3-6 for detailed information.
Drive mode switch "MODE"
WARNING
Do not change the D-mode while the
vehicle is moving.
ECA10062
Using this switch changes the drive
mode to "STD", "A", or "B" in the follow-
ing order:
STD A B STD
The throttle grip must be completely
closed in order to change the drive
mode. (See page 3-17 for an explana-
EAU59011
tion of each drive mode.)
TIP
EAU59001
/
"
EAU77020
EWA15341
3-19
The current drive mode is saved
when the key is turned to "OFF".
The selected mode is shown on
the drive mode display. (See page
3-9.)
Advertisement
Table of Contents
Troubleshooting
