Operation - Hammerhead HLMT100 Manual

OPERATION

1. HOW TO CHARGE THE COMPACT LASER MEASURING TOOL
NOTE: The compact laser measuring tool is shipped partially charged; charge the battery before
first use.
Optimum performance can be reached by recharging the tool for approximately 2 hours after
use. It is not recommended to recharge the tool for more than 24 hours after each use.
The power supply can be used with normal household voltage of 100-240 volts AC.
a. Insert the USB interface of the USB charging cable into the power supply.
b. Insert the charging plug into charging port, making sure that they are properly
connected.
c. Connect the power supply (together with USB charging cable) to the power outlet. The
tool will turn on automatically. The battery indicator will begin to flicker on the LCD
display to indicate that the compact compact laser measuring tool is charging.
d. When charging is complete, the full-battery indicator will appear on the LCD display.
Remove the USB charging cable from the measuring tool; the tool will turn off within
3 seconds. If the USB charging cable remains connected to the compact laser
measuring tool, the tool will remain "ON".
NOTE: The compact laser measuring tool will not turn off when the USB charging cable is
removed during normal charging until 3 minutes have elapsed.
NOTE: Do not operate the power supply in an area of extreme heat or cold. It works best
at normal room temperature. The base of tool or power supply may become warm during
charging.
1
USB INTERFACE
8
CHARGING PLUG
CHARGING PORT
COMPACT LASER MEASURING TOOL