Dynojet POWER COMMANDER V Installation Instructions Manual page 5

FIG.G
FIG.H
FIG.J
19-008 www.powercommander.com
12 On the left hand side of the ATV remove the two bolts that hold the ignition coil
bracket to the frame (Fig. G).
To access the bolt on the left you will need to pull the spark plug wires from the
coils.
Removing the coil bracket will allow you access to the #1 injector harness.
13 Locate the stock #1 injector harness on the left hand side of the ATV.
This may be located by following the wiring harness back from the injector until
you find the connector shown in Fig. H.
14 Unplug this connector
15 Plug the ORANGE colored wires from the PCV in-line of the stock wiring
harness (Fig. J).
16 Reinstall the coil bracket.
2009-2010 Polaris 800 PCV - 5