Fit The Blade; Blade Settings - Husqvarna MS 360 G Operator's Manual

Fit the blade

WARNING! The engine should be
!
switched off, and the stop switch in
STOP position.
Note: The blade is mounted from delivery.
The blade is mounted from delivery.
• Always wear heavy-duty gloves when handling the
cutting attachment. This is extremely sharp and can
easily cause cuts.
• Remove the blade nut. Remove the blade flange.
• Check that the blade, blade flange and blade shaft are
undamaged. Clean the contact surfaces of the blade
and the blade flange.
• Fit the blade, blade flange and nut. Make sure that the
blade will rotate in the direction indicated by the arrow
on the blade.
ASSEMBLING AND ADJUSTMENTS

Blade settings

Depth stop adjustment
Set the depth stop so that the blade gets maximum depth
without cutting into the cart.
CAUTION! This must be done while the blade is not
rotating.
The depth stop should be adjusted when switching to
other blade sizes. Check the stop depth regularly or
there is a risk that the cutting slot and the water system
will not function correctly.
• Push down the cutting arm until the blade hits the
bottom of the slot in the cart.
• Hold down the cutting arm in this position.
• Screw down the knob (2) for setting the stop depth
until the end of the knob abuts the underlying surface
in order to set up the stop depth of the blade. Turn
another turn to raise the head from the cart slightly.
• Tighten the locking nut (3).
• Tighten the locking knob for depth adjustment (1) with
the cutting arm still pushed down to its lowest position.
• Check the position of the blade by moving the
conveyor cart to its forward and rear end position. The
blade should never hit the cart.
2
3
1
–
English 11