Fit The Blade - Husqvarna WS220 Operator's Manual

Fit the blade

WARNING! Never mount or dismount the
!
blade or blade guard without first pulling
out the power cable running to the saw
unit. Carelessness can result in serious
personal injury or even death.
It is recommended that Husqvarna diamond blades are
used together with the WS 220. Maximum starting blade
is 600 mm, and maximum size for blades for deeper cuts
is 900 mm. Talk to Husqvarna retailers for
recommendations regarding blades for different
materials.
• Loosen the blade bolt and remove the outer blade
flange.
• Clean the clamping surfaces on the inner and outer
blade flange, and check that they are free from
grades.
• Also clean and check the clamping surfaces on the
blade.
• The inner blade flange has a center spacer for 60 mm
factory mounted blade center holes, if blades with 1'
center holes are used, the 60 mm spacer may be
removed.
• Check which rotational direction should be chosen
with regard to the water spray, for vertical cutting it
may be advantageous to direct the water spray down
towards the floor.
• Then mount the blade according to the rotation arrow
on the blade. If the blade lacks a rotation arrow the
diamonds in the segments may be inspected, since
the exposed part of the diamonds should lie in the
blade's rotational direction.
16 – English
ASSEMBLING AND ADJUSTMENTS
• Guide the blade up on the center guide and place it
against the inner blade flange, hold the blade in place
and then mount the outer blade flange with the blade
bolt and tighten to 45 nm.
• Check the angle between the blade and the wall using
a large set square. If the blade is not perpendicular to
the wall, this may now be adjusted on the wall
brackets by loosening the locking screw for angle
adjustment, and then angling the wall brackets until
the blade is in a perpendicular position.
90°
• Adjust the blade angle as needed against the
concrete surface by loosening the locking screw for
angle adjustment and angling both wall bracket halves
in relation to each other.
WARNING! Exercise care when
!
assembling the blade so that it does not
risk becoming loose when cutting.
Carelessness can result in serious
personal injury or even death.