Proflex XTR5 User Manual page 8

XTR5 Elliptical Cross Trainer
17. Lower the right and left handlebars (30 (not shown) and 31) down over
the tubes at the top-front of the pedal arms. The handlebars should be
positioned so that they extend forward and the square mounting holes
are facing toward the rear of the machine.
18. Attach each handle bar using 2 M6 extension nuts (32), inserted from
the front of the machine, and 2 M6x16 screws (33). Tighten (rotate right)
the screws using the Allen key.
32
19. Remove the pre-assembled screws (35) from the rear of the console (34), then connect the wiring
between the console and centre brace (N).
20. Attach the console to the top of the centre brace using the 4 screws (O) – there are two possible
positions – select the one most comfortable for you, then plug the pulse sensor cable from the stationary
handle into the rear of the console (P).
35
34
Push the applicable plastic nut caps on to the tops of the fasteners identified by
When correctly assembled, the machine should resemble the image below and is ready for use.
E&OE
33
N
Moving
The unit can be tilted onto its wheels for easy moving and
storage. Firmly grasp the stationary handlebar with both hands.
Next, carefully tilt the equipment forward until it rolls freely on
the transport wheels.
© 2017 Proflex
31
P
O
, below (on both sides).
8